jrod
2nd Gear
A Little Bit Closer
Posts: 119
|
Post by jrod on Mar 5, 2013 20:58:02 GMT -5
I have one carb that the heat insulator piece thingy(brown piece in the carb throat that tightens against the intake) is half broken and I don't have the pieces. It still goes on the intake about 1/4" but I think it will probably vibrate off since it is only the last little bit and the clamp won't work as intended. Can you replace these with anything?? I could make an aluminum spacer, but it would defeat the purpose. Do they sell the spacers/insulators some where? I also need 2 sets of bolts and nuts for the carb clamps can you get these some place? Any suggestions are welcome.
|
|
|
Post by lc on Mar 5, 2013 21:07:18 GMT -5
H1 carbs are a dime a dozen on evilbay. (Or a member here may have a good one for you) Get another body to use. Be sure to transfer ALL the components from the scrap carb (assuming all your present carbs are matched and proper).
I used to replace the pinch bolt you refer with a hardened allen head cap screw and nut.....
J
|
|
jrod
2nd Gear
A Little Bit Closer
Posts: 119
|
Post by jrod on Mar 6, 2013 15:14:24 GMT -5
Thanks LC, you came to the rescue again, I was thinking the same about the carb, but thought there might be another way. Not much in ebay right now, i will post a wanted add on the site I guess
|
|
|
Post by daffey1 on Mar 6, 2013 17:07:36 GMT -5
I think I might have an H1 carb for you. Is is the complete carb you want?
|
|
jrod
2nd Gear
A Little Bit Closer
Posts: 119
|
Post by jrod on Mar 6, 2013 17:08:54 GMT -5
Thanks Bud, Just need the body but I will take the whole carb. PM sent
|
|
jrod
2nd Gear
A Little Bit Closer
Posts: 119
|
Post by jrod on Mar 7, 2013 22:46:03 GMT -5
daffey1 is the man! hooked me up with the much needed parts! Thanks bud
|
|