|
Post by drewski on Jan 28, 2010 11:20:35 GMT -5
O'k. From the pic, it looks to me like the exhaust has been "snaked" around the down tube. Follow me here. The measurement David gave me was 9" centre to centre on the down tubes. (approx.) The inside to inside measurement from the # 1 to 3 cylinder exhaust flange is 9". I think, depending on the set-back measurement (tube to flange), this conversion could be done. Now you can make fun of my drawing! ;D ;D Walms would have a "Solidworks rotating mock" up done by now, but I'm not so gifted! We might have to move this thread to the "Projects" section!!
|
|