|
Post by gsxrtriple1 on Apr 16, 2023 11:58:03 GMT -5
Hi all having a hard time trying to set points and set ignition timing on my 350 i ha e new points and condensers Problems im having is when setting the points gap to spec i then rotate engine I have a battery and bulb connected now the bulb should go out when points are just opening but this is not happening when the marks on rotorine up even if i move the points plate its still not lining up am i gaping the points at the wrong position any help would be appreciated Simon
|
|
|
Post by kawonda750 on Apr 16, 2023 13:41:05 GMT -5
rotate the crank until you see the largest points gap then set. You can usually see the high point of the points cam. Do you have a dial gauge to find the correct BDTC firing point ?
I am pretty sure that the light should come ON when your points just start to open.
|
|
|
Post by mraxl on Apr 17, 2023 5:23:39 GMT -5
Hi all having a hard time trying to set points and set ignition timing on my 350 i ha e new points and condensers Problems im having is when setting the points gap to spec i then rotate engine I have a battery and bulb connected now the bulb should go out when points are just opening but this is not happening when the marks on rotorine up even if i move the points plate its still not lining up am i gaping the points at the wrong position any help would be appreciated Simon kawatriple.com/pointstiming.htm
|
|