|
Post by bolly on May 25, 2019 9:58:54 GMT -5
good friend of mine owned this 10 yrs, took some parts off it and it sat that long... I should have all the parts except maybe a missing airbox, needs fork tubes for sure though!! I'm gonna assemble her in the next week or so and see if she'll fire!!!!
|
|
|
Post by Curtis on May 25, 2019 14:51:52 GMT -5
I think I have good forks here
|
|
|
Post by bolly on May 25, 2019 16:26:20 GMT -5
Awesome Curtis!!!
Once I'm into her I'm hopin she isn't missing much... I'll make a list!
|
|
|
Post by Curtis on May 25, 2019 18:03:52 GMT -5
Not sure but I may have an exhaust here as well - not a 4 into 1 but a 4 into 2 aftermarket
|
|
|
Post by bolly on May 30, 2019 16:17:52 GMT -5
thanks anyways Curtis but he wants a 4 into 1 and hopefully a kerker
|
|
|
Post by bolly on Jun 18, 2019 12:27:10 GMT -5
hope someone can be of help?
major issue is motor was full of oil/gas mix and generator was full as well, don't know if oil will dissolve the rotor winding varnish?
since the motor was full, does it have to come apart before I try to start it?
what other issues can I expect due to it being full?
|
|
|
Post by Curtis on Jun 18, 2019 17:26:35 GMT -5
Drain it Fresh oil and filter New needles and seats in the carbs
|
|
|
Post by bolly on Jun 19, 2019 7:11:12 GMT -5
Thanks a lot Curtis!!
That's all been done (other than carbs), had to jump the solenoid and she rolls over, shes closer!!
|
|
|
Post by Curtis on Jun 19, 2019 7:17:20 GMT -5
Thanks a lot Curtis!! That's all been done (other than carbs), had to jump the solenoid and she rolls over, shes closer!! Good luck !
|
|
|
Post by bolly on Jun 26, 2019 7:07:37 GMT -5
thx Curtis!!! hopefully someone can still help, we need the throttle cable bracket, carbs are BS34 Mikunis, I seen a few off xs650 that look similar
|
|
|
Post by bolly on Jun 26, 2019 8:31:59 GMT -5
Centre to center of them holes is 56mm
|
|