|
Post by zambia on Jun 3, 2015 14:50:24 GMT -5
Has anyone replaced the oil feed pipe (tank to pump) on an H2 or late H1? If so, what did you use? I can't find any decent piping..don't want to use anything like fuel line which doesn't resist pinching. I found an NOS one for $55 plus shipping...but that seems a bit steep!
|
|
|
Post by Walms on Jun 3, 2015 14:56:23 GMT -5
I just crappy ole vinyl tubing for mine... Soft enough to be clamped with a hemostat (roach clip) but yet hard enough that it's not likely to kink on its own.
|
|
|
Post by zambia on Jun 3, 2015 15:12:52 GMT -5
I just crappy ole vinyl tubing for mine... Soft enough to be clamped with a hemostat (roach clip) but yet hard enough that it's not likely to kink on its own. I have some of that - was worried my carb would pinch it shut...you know how these H2's vibrate..
|
|
|
Post by Walms on Jun 3, 2015 15:14:41 GMT -5
The oil tends to harden it up a bit over time.
|
|
|
Post by kawonda750 on Jun 3, 2015 17:09:50 GMT -5
I went with Andre's replacement for H1 oil line . It works fine. I think I had to cut a bit off but otherwise it was fine.
|
|
|
Post by shiloh on Jun 3, 2015 18:22:06 GMT -5
Tygon is what I use. I bought mine at a TSC store, get enough of what ever you use for ample routing to avoid any pinching issues.
|
|